This is an old revision of the document!
esp8266
MAY NEED ADDITIONAL 3.3V POWER
arba galima ideti 2000mf kondika tada viskas susireguliuoja ir veikia nuo usb serial adapterio
valgo 72ma
naudoti prisijungbimui sita terminala: https://www.compuphase.com/software_termite.htm
yra labai geras programatorius su kondensatoriu ir jam pakanka usb dudoamu 3.3. voltu
IF ALL WORKS OK
COMMAND LIB IS HERE:
https://room-15.github.io/blog/2015/03/26/esp8266-at-command-reference/#AT
https://www.espressif.com/sites/default/files/documentation/4a-esp8266_at_instruction_set_en.pdf
pakeisti ssd ir palikti atvira:
AT+CWSAP=“Hidden treasure 13”,“”,13,0
programavimas su arduino ide reikia spaudyti tuos flash ir reset butonus
https://create.arduino.cc/projecthub/ROBINTHOMAS/esp8266-esp-01-webserver-7248ca
BLINK
// the setup function runs once when you press reset or power the board void setup() { // initialize digital pin 13 as an output. pinMode(2, OUTPUT); } // the loop function runs over and over again forever void loop() { digitalWrite(2, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(2, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }