**pirma karta - SPAUDI boot pajungi usb tada spusteli reset ir tada atelidi boot**

**Arduino IDE → Tools → USB CDC On Boot → Enabled.**


{{:esp32:pasted:20251224-092657.png}}
{{:esp32:pasted:20251224-093146.png}}

===== ESP32-C6 Super Mini Board =====

The **ESP32-C6 Super Mini** is an ultra-compact development board based on the ESP32-C6 SoC, designed for modern low-power IoT applications where size matters.

==== Key Features ====
  * 32-bit RISC-V CPU (up to ~160 MHz)
  * Wi-Fi 6 (2.4 GHz) support
  * Bluetooth Low Energy 5.x
  * Ultra-low-power operation
  * On-board PCB antenna
  * USB-C (or Micro-USB on some variants) for power and programming
  * Integrated flash memory (commonly ~4 MB)
  * Reset and Boot buttons

==== Interfaces ====
  * GPIO (limited number due to small size)
  * UART
  * SPI
  * I²C
  * PWM
  * ADC

==== Power ====
  * 3.3 V logic level
  * Designed for battery-powered and energy-efficient projects

==== Development Support ====
  * ESP-IDF
  * Arduino framework

==== Typical Applications ====
  * Smart home and Matter-enabled devices
  * Sensors and IoT nodes
  * Wearables and compact embedded systems
  * Prototyping in space-constrained designs

==== Notes ====
Due to its very small form factor, the Super Mini board may not be breadboard-friendly and has fewer exposed GPIO pins compared to standard ESP32 development boards.


<code cpp>

void setup() {
  // put your setup code here, to run once:

  Serial.begin(115200);
  while (!Serial);

  Serial.println("Hello World");
  Serial.println("ESP32-C6 Development Kit");
  Serial.println("--------------------------------");
}

void loop() {
  //blink led
  pinMode(15, OUTPUT);
  digitalWrite(15, HIGH);
  delay(1000);
  digitalWrite(15, LOW);
  delay(1000);
}

</code>