Differences

This shows you the differences between two versions of the page.

--- esp32:esp32-c6_super_mini_board [2025/12/24 09:20] – created aistis
+++ esp32:esp32-c6_super_mini_board [2026/03/22 14:17] (current) – aistis
@@ Line 1: / Line 1: @@
-{{:esp32:pasted:20251224-091937.png}}
+**pirma karta - SPAUDI boot pajungi usb tada spusteli reset ir tada atelidi boot**
-{{:esp32:pasted:20251224-091954.png}}
-ESP32-C6 is a low-power IoT SoC from Espressif Systems focused on modern wireless standards.
+**Arduino IDE → Tools → USB CDC On Boot → Enabled.**
-Key points
-•	CPU: 32-bit RISC-V (up to ~160 MHz)
-•	Wireless: Wi-Fi 6 (2.4 GHz) + Bluetooth LE 5.x (incl. extended advertising)
-•	Security: Secure boot, flash encryption, hardware crypto, TEE features
-•	I/O: GPIO, SPI, I²C, UART, PWM, ADC
-•	Power: Designed for ultra-low-power IoT nodes
-•	Ecosystem: ESP-IDF, Arduino support available
+{{:esp32:pasted:20251224-092657.png}}
+{{:esp32:pasted:20251224-093146.png}}
+===== ESP32-C6 Super Mini Board =====
+The **ESP32-C6 Super Mini** is an ultra-compact development board based on the ESP32-C6 SoC, designed for modern low-power IoT applications where size matters.
+==== Key Features ====
+  * 32-bit RISC-V CPU (up to ~160 MHz)
+  * Wi-Fi 6 (2.4 GHz) support
+  * Bluetooth Low Energy 5.x
+  * Ultra-low-power operation
+  * On-board PCB antenna
+  * USB-C (or Micro-USB on some variants) for power and programming
+  * Integrated flash memory (commonly ~4 MB)
+  * Reset and Boot buttons
+==== Interfaces ====
+  * GPIO (limited number due to small size)
+  * UART
+  * SPI
+  * I²C
+  * PWM
+  * ADC
+==== Power ====
+  * 3.3 V logic level
+  * Designed for battery-powered and energy-efficient projects
+==== Development Support ====
+  * ESP-IDF
+  * Arduino framework
+==== Typical Applications ====
+  * Smart home and Matter-enabled devices
+  * Sensors and IoT nodes
+  * Wearables and compact embedded systems
+  * Prototyping in space-constrained designs
+==== Notes ====
+Due to its very small form factor, the Super Mini board may not be breadboard-friendly and has fewer exposed GPIO pins compared to standard ESP32 development boards.
+<code cpp>
+void setup() {
+  // put your setup code here, to run once:
+  Serial.begin(115200);
+  while (!Serial);
+  Serial.println("Hello World");
+  Serial.println("ESP32-C6 Development Kit");
+  Serial.println("--------------------------------");
+}
+void loop() {
+  //blink led
+  pinMode(15, OUTPUT);
+  digitalWrite(15, HIGH);
+  delay(1000);
+  digitalWrite(15, LOW);
+  delay(1000);
+}
+</code>