Differences

This shows you the differences between two versions of the page.

--- arduino:esp8266 [2017/07/17 23:37] – aistis
+++ arduino:esp8266 [2017/10/02 14:57] (current) – aistis
@@ Line 1: / Line 1: @@
-NEED ADDITIONAL 3.3V POWER
+esp8266
-arbagalima ideti kelis kondikus tada viskas susireguliuoja
+{{:arduino:pasted:20170717-173804.png}}
-valgo 72ma,
+MAY NEED ADDITIONAL 3.3V POWER
+arba galima ideti 2000mf kondika tada viskas susireguliuoja ir veikia nuo usb serial adapterio
+valgo 72ma
+naudoti prisijungbimui sita terminala: https://www.compuphase.com/software_termite.htm
+{{:arduino:pasted:20170719-155837.png}}
-{{:arduino:pasted:20170717-173804.png}}
 {{:arduino:pasted:20170717-173739.png}}
+yra labai geras programatorius su kondensatoriu ir jam pakanka usb dudoamu 3.3. voltu
+{{:arduino:pasted:20170719-155750.png}}
 IF ALL WORKS OK
@@ Line 16: / Line 26: @@
 https://room-15.github.io/blog/2015/03/26/esp8266-at-command-reference/#AT
+https://www.espressif.com/sites/default/files/documentation/4a-esp8266_at_instruction_set_en.pdf
+pakeisti ssd ir palikti atvira:
+AT+CWSAP="Hidden treasure 13","",13,0
+----
+programavimas su arduino ide
+reikia spaudyti tuos flash ir reset butonus
+https://create.arduino.cc/projecthub/ROBINTHOMAS/esp8266-esp-01-webserver-7248ca
+BLINK melyna wifi lempute
+<code c++>
+// the setup function runs once when you press reset or power the board
+void setup() {
+  // initialize digital pin 13 as an output.
+  pinMode(1, OUTPUT);
+}
+// the loop function runs over and over again forever
+void loop() {
+  digitalWrite(1, HIGH);   // turn the LED on (HIGH is the voltage level)
+  delay(100);              // wait for a second
+  digitalWrite(1, LOW);    // turn the LED off by making the voltage LOW
+  delay(100);              // wait for a second
+}
+</code>
+deep-sleep kad miegotu, reikia sujungti 2 kontaktus ir nuzudyti power led'a
+https://hackaday.com/2015/02/08/hack-allows-esp-01-to-go-to-deep-sleep/