Differences

This shows you the differences between two versions of the page.

--- arduino:bk3231 [2017/08/07 20:46] – aistis
+++ arduino:bk3231 [2017/08/07 20:49] (current) – aistis
@@ Line 2: / Line 2: @@
 b26782h
+defaultinis pairinimosi slaptazodis 1234
 {{:arduino:pasted:20170807-192443.png}}
@@ Line 40: / Line 42: @@
 Next: XBEE FT232RL Chip Serial Ports Expand Board USB to TTL Adapt Base
+</code>
+jungti TX(1) i arduino 10, jungti rx(2) i arduino 11
+<code c>
+#include <SoftwareSerial.h>
+SoftwareSerial mySerial(10, 11); // RX, TX
+void setup() {
+  // Open serial communications and wait for port to open:
+  Serial.begin(38400);
+  while (!Serial) {
+    ; // wait for serial port to connect. Needed for native USB port only
+  }
+  pinMode(LED_BUILTIN, OUTPUT);
+  Serial.println("Goodnight moon!");
+  // set the data rate for the SoftwareSerial port
+  mySerial.begin(9600);
+  mySerial.println("Hello, world?");
+}
+void loop() { // run over and over
+  mySerial.println("Hello, world?");
+  digitalWrite(LED_BUILTIN, HIGH);
+  delay(1000);
+  digitalWrite(LED_BUILTIN, LOW);
+  delay(1000);
+  /*
+  if (mySerial.available()) {
+    Serial.write(mySerial.read());
+  }
+  if (Serial.available()) {
+    mySerial.write(Serial.read());
+  }
+  */
+}
 </code>